A lot of the mangling I feared was successfully mitigated, like at the front bottom. Though the clogs at the rear face DID happen but I was able to declog it fairly well compared to what it originally was. Support in the center of the model was substantial (but not awful), I'll dig that out when I can. One of the creases in the temple of the rear face is longer than the other, but I can't tell if it's due to support or preliminary support removal, but at least it could have been worse. There did seem to be some lamination issues, but nothing severe. On that note, the grain effect was beautiful! Considering I went for the cheapest wood-fill print rather than any specific wood like Coconut I was a bit worried that there wouldn't be a beautiful grain, but there is one (one that looks quarter-sawn), and I fully intend to stain this model to make it have a coppery "tone". I did also end up scratching away some other imperfections. This was a slow process but the final result was epic!
