The quality of the print is pretty good. There's some ghosting and some imperfections but overall the print is pretty clean.
The big problem is the support material. The parts were designed to not need supports, but supports were added *everywhere*, even in small screw holes that take m2 screws. It is completely impossible to remove the supports from these small spaces, which makes the part unusable for me since I cannot fit the screws.
I thought that maybe the support material was water soluble (sr30?), but dunking it in warm water for over an hour did not change the material properties in any way, so not sure if there is a way to remove supports other than trying to pry them away.
Supports are really hard to remove around thin walls. There is way too much material, and it's folded around creases and corners, making it nearly impossible to remove without cracking the print, which is exactly what happened to me.
tl:dr; great prints ruined by supports that cannot be removed
