This is a mount for a [Byonics BFoxCon Baofeng Foxhunt Controller](http://byonics.com/piccon) that allows the BFoxCon to be enclosed and mounted on the back of the
...さらに表示 [Baofeng UV-5R](https://baofengtech.com/uv-5r). This case is sized and is intended to be used with the 2.5mm pin headers (TTL serial and reset) soldered to the BFoxCon board.
It also provides support and protection for the speaker/mic cable and the BFoxCon power cable using a reconfigured version of the [UV5R Speaker Mic Cable Support Bracket](https://www.thingiverse.com/thing:306288) by EngineerChris. This bracket is optional and the case may be used without it.
There are three versions of the top lid. The first has a hole through which the LED on the BFoxCon can be observed, and is intended for prints using an opaque material.
The second has an additional window for the 4-pin TTL serial interface connector to program the BFoxCon with.
The third has no hole, and is intended for prints using a translucent material through which the LED can be seen.
For reference, the LED states are:
+ LED on Solid - Transmitting
+ LED Fast Flash (20Hz) - Receiving DTMF
+ LED Medium Flash (5 Hz) - Receiving configuration tones
+ LED Slow Flash (1 Hz) - In a transmit sequence but currently off the air.
+ LED Off - Not in a sequence
