3D model of terrain4print. The models were repaired and checked for printability.
Added magnet holes like for the entrances
This is a set of pieces that lets you
...さらに表示 make hills for wargaming and roleplaying games. The pieces can be snap fitted together with the applied clip. There are different sizes so check out the possible combinations. Not everything fits with everything visually.
You can make full round hills, or edge hills (from two pieces) or corner hills (from one piece).
You should be able to print with very low infill. I use 5% honeycomb.
The hills on the pictures have been painted with different techniques. The desert hill is painted dark muddy brown the drybrushed with a lighter color. They dark grassy hill is painted black and then drybrushed with lighter and lighter grays. The lighter hills are painted white and then washed with yellow, red, brown and black.
The hills are textured and flocked with a simple technique. Thin down PVA glue with 50% water. Paint on. Sprinkle sand and grit on them. Let dry. Spray or paint with PVA glue 80% water. Let dry again.
http://twitter.com/KruseMarkus
