3D model of teachingtech
The models were repaired and checked for printability.
these parts will allow you to use your BLtouch with:
Auto levelling at the start
...さらに表示 of each print in only 30 seconds
Accurate/symmetrical spacing of probing points
Automatic adjustment for any build surface, regardless of thickness
The side mount is for use when the standard part cooling fan is in place.
The front mount is when a rear mounted cooling fan has ben installed, such as the Ciii cooler
Two variations the front mount are now included for those who find the original design puts the probe too close to the bed. They are titled accordingly.
Editing the value for 'plane 1' controls the height the sensor sits at relative to the metal mounting surface. My original design for 6mm. A smaller number moves it up, a larger number moves it down. Now you can edit to whatever offset you like.
Printer:
Cocoon Create Touch
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
20%
Notes:
Manual support will help the side mount print cleanly.
M3 x 10mm bolts with M3 nuts are all that is required.
www.youtube.com/c/teachingtech
