3D model of thenewhobbyist
The models were repaired and checked for printability.
These are the printable parts required to build a "Speaky".
I created
...さらに表示 this case to hold a set of desktop speakers and a Raspberry Pi that I'm using as an Airplay receiver. I based the case design (loosely) on some mid-century speakers I found on Google Images.
The bolts holding the backplate on were generated using aubenc's "Poor man's openscad screw library". I've also included a modified version of the bolt that act as a cable organizer.
Rafts:
No
Supports:
Yes
Resolution:
.2mm
Infill:
30%
Notes:
Print the main body of the print with supports enabled. The other parts will print fine without raft/supports.
The main body is a long print (13 hours!) so made sure your platform is nice and level before starting.
1. Print BoomBox1_TNH with supports. (raft optional)
2. Print BoomBox2_TNH & BoomBox3_TNH without supports
http://twitter.com/TheNewHobbyist
