3D model of daandruff
The models were repaired and checked for printability.
This is a small counter to keep track of your characters life (Or any other number you
...さらに表示 would like). It's easy to make for bigger or smaller numbers just by printing extra number-cogs. It's hold together by a small rubber band that is attached to the end-caps inside of the counter (You should be able to pull it through the arc and around the part to fasten it). When changing it, you just pull it apart a little, turn the cogs and then the rubber band locks it in place again.
Printer:
M3D
Rafts:
No
Supports:
No
Resolution:
150 Microns
Infill:
No
