The Markforged Mark Two is an industrial machine perfect for creating Strong and Accurate Production parts made from Onyx (Nylon with chopped carbon fiber) or...さらに表示 Precise PLA, we also are able to do Continuous fiber inlays with both Carbon Fiber and Kevlar.
If you are new to the world of continuous fiber printing we will help you through the process to make sure your prints come out as strong as possible!
---Specifications and Design Guidelines---
Minimum Part Dimensions:
X: 1.6 mm (0.063”)
Y: 1.6 mm (0.063”)
Z: 0.8 mm (0.031”)
Minimum Unsupported Overhang Angle
θ: 40 degrees
This is the minimum angle to the horizontal at which a feature of a part can print
without needing supports to hold it up. Supports will be generated automatically for angles
below 45 degrees, but may not be needed in all cases.
Minimum Hole Diameter:
XY: 1.5 mm (0.059”)
Z: 1.0 mm (0.039”)
Holes with too small a diameter may close off during printing or print inaccurately.
Horizontal surface holes (Z) print more precisely than vertical surface holes (XY).
Minimum Post Diameter:
XY: 1.6 mm (0.063”)
Z: 2.0 mm (0.079”)
Posts with too small a diameter may not print precisely. Consider adding dowels
or pins to your part for strong vertical posts to avoid shear along layer lines.
3Dモデル
モデルの画像
他のファイル
3Dモデル処理中
Need something special?
Request a Free Quote
Total: 11.63
USD
Our site uses cookies. By continuing to use our site you are agreeing to our Privacy Policy
