3D model of aubenc. The models were repaired and checked for printability.
A quick'n'dirty OpenSCAD (sorry, there's nothing parametric in it) to
...さらに表示 allow us to mount those IKEA clothes dryer in a wall.
We have been using it for a couple of months with all kinds of loads and it's still holding in place... use at your own risk.
You'll need two of them and two screws (and plugs) for each one.
The screws should have a diameter of 4mm (or less, better no...) and at least 45mm length.
I printed them is ABS, don't remember the layer height but quite coarse (0.20 or 0.25mm), one extra shell (2 in total), 35% infill and finished them with an acetone bath.
