3D model of thenewhobbyist
The models were repaired and checked for printability.
I have way too many pairs of cheap sunglasses. I tend to keep
them on my kitchen
...さらに表示 counter so I can grab a pair on the way out of the house. Of course this means I always have a messy pile of sunglasses in the way.
I thought I'd use my printer to clean up my kitchen by mounting them all on my fridge for easy storage and selection.
I've added four nose options to choose from, but go ahead and add a pin hole using TBuser's pins library to create your own faces!
1. Open in Customizer.
2. Enter measurements from your glasses for both the bridge of your glasses as well as the overall thickness.
3. Pick your nose.
4. Print!
5. Glue a 3/4 inch diameter coin shaped magnet to the back of the mount.
6. Stick it to your fridge!
http://twitter.com/TheNewHobbyist
